PW Paver Wash™

PW Paver Wash™ Instructions

1. Prepare the Surface

   1. Thoroughly sweep the surface of joint sand, dust, debris, or loose material.
   2. Spot clean if needed with one of these SRW Specialty Clean™ products:
      
      1. CDX Cleaner & Degreaser X-treme™
      2. RE Rust Eliminator™
      3. M3C Mold, Moss & Mildew Cleaner™
      4. OC Organic Stain Cleaner™
   3. Recommended application temperatures are 50 – 80°F (10 – 27°C)

2. Dilute and Saturate

   1. Saturate the surface and surrounding area (including vegetation) thoroughly with water.
   2. Do not allow the product to dry on the surface. Re-spray with water, if needed, to keep the area wet. A 2-person application is recommended.

3. Apply the Mixture

   1. Apply PW Paver Wash™ directly to the surface with a sprinkler can. Do not dilute.
   2. With a stiff bristle brush, scrub area immediately and thoroughly.
   3. For large areas, work in 200 sq. ft. (18.58 sq. m.) sections.
   4. If working on an incline, start at the highest point, working in small sections. Scrub from the bottom of the section, pushing excess PW Paver Wash™ up over the job.

4. Rinse the Surface

   1. Immediately rinse the surface and surrounding areas (including vegetation) thoroughly with clean water until all traces of foam disappear.
   2. Repeat if necessary. Let dry.
   3. Wait 24 hours before applying an SRW Products sealer.

5. COVERAGE

   1. Up to 200 sq. ft. per gallon (18.58 sq. m. per 3.78 liters). Coverage may vary depending on surface & application. 

6. CLEAN UP & STORAGE

   1. Rinse off all equipment with soap and water and let dry. Store container in a cool area with cap or lid firmly in place. KEEP FROM FREEZING.

7. USER TIPS

   1. Test inconspicuous area before starting the general application to
      ensure desired results.
   2. Wear eye, skin & respiratory protection when applying.
   3. Prolonged contact of cleaner on metal or other surface may result in etching or damage.
   4. Saturate vegetation before and after application.
   5. Wait 60-90 days for new pavers to cure before applying PW.
   6. Not for use on sealed surfaces, wetcast or natural stone.